Linkage and Hardware

This linkage is used when a custom length is needed. Cut tube to the desired length and weld threaded insert into the end of tubing.

This picture is full assembly with Rod End Bearings installed.

Stainless Steel.

Stainless Steel, 3/8" x 16". This threaded insert is used on all support headers under the white bushing blocks. Order 750-900-0004 for insert with installation tool.

3/8" ID. Stainless Steel.

5/16" ID. Stainless Steel.

5/16-24 x 1 3/4 SS Bolt with nut and special washers.

5/16-24 x 2 1/2 SS bolt with nut and special washers.

Stainless steel.

This kit is for the Main Drive Linkage at the gearbox connection. It includes 2 bearings, spacer tube, snap ring, and all hardware to rebuild the unit.

This rod end bearing housing is stainless steel with a two piece silicone bronze housing.

This arm is 4" from center and has a 3/8" hole in one end.

This arm is 3" center to center with 5/16" hole.

Bushing block for housing linkage shaft.

This tubing is used when a custom length is needed. Cut tubing to desired length and weld threaded insert into end of tubing.